I just have to assume there's a better way than what I'm doing, 'cus it's quite tedious.

Is there, perhaps, a field that would accept something like 'C 4.7UF 5.0' (I just made that up) to return any 4.7 uF cap with a 5 mm lead spacing, regardless of manufacturer or exact manufacturer part number?

Gibberish unless you work in TDK's stocking department. Is there some kind of standard labeling for parts that is not manufacturer dependent that I can use within the DipTrace filter? For example, the exact part number for my 4.7 uF cap is 'FG28X5R1E475KRT06'. 1) Open your design in Schematics, 2) Switch the current Library Group to Projects Libraries (left side of program window - Library Panel), 3) Select 'Design Cache' Library, 4) Open the menu from Library Panel - Library Tools - Save Design Cache as. But the best I've been able to do so far is to hunt-and-peck, just randomly searching through all the DipTrace cap components looking. Re: Want to make new part from existing part, change the pat. I know that Digikey has a KiCad library that can be imported, but there's only a few thousand components in it.īack to my 4.7uF example in the OP, I'm sure there are many components for a capacitor within DipTrace that have a pattern suitable for my cap with 0.5mm dia leads spaced at 5mm. But how do I find a suitable match?Ĭlick to expand.I've certainly used filters, but haven't seen a DigiKey library within Diptrace. There is nothing particularly remarkable about this, and I'm sure there are many other parts with the exact same characteristics. It has a lead diameter of 0.5mm and a lead spacing of 5.0mm. Take, for example, a 4.7 uF through-hole ceramic capacitor from TDK. I'd be quite content to use a substitute symbol and pattern, but I don't know how to find one with exact hole sizing and spacing that matches my actual part. I know how to create a component from scratch in the component editor and pattern editor, but I don't want to have to do that for every piece in my project. With millions of components in the world out there, I'm not surprised that DipTrace's library doesn't have every one, but I am surprised that of all the parts I've looked for, it hasn't had a single one. But so far, not a single component I've looked for, from converters, resistors, inductors, to opamps, has shown up within the DipTrace library. I'm working on a schematic in DipTrace with the intent of creating a PCB, so the patterns associated with the component matters. I've searched a lot of threads and tutorials for this, but have so far not found anything helpful.

Nine volt battery pattern in diptrace